When the button is pressed the Arduino board will put pin 2 in HIGH state, meaning 5V on pin 2. This voltage is used to drive the transistor that will switch ON the relay and the load (in our case the ...

Arduino custom switch console project. ... The ‘unhackable’ switch, which resembles a MIDI sequencer input, runs on an Arduino Nano Every and uses a relay to directly control the power state.

The relay board is meant to fit inside the blue box along with the four sockets, ... Check out that light switch rave after the break. ... 27 thoughts on “ Arduino Controlled Four Socket Outlet ” ...

It does actually have a tamper switch, so it gets a point for that I suppose. What I did was remove the coil (very easy) and put that outside, with the rest of the unit inside. (The coil is about ...

It’s a fairly simple project, too: just hook an Arduino Uno up to a motion sensor and an electronic switch called a relay, then plug in your fan, and you’re good to go.

Goal: Control lights and appliances using relays, sensors, and a web interface. Components Needed: Raspberry Pi 4. Arduino Uno. 4-channel relay module. PIR motion sensor. Steps: Use Arduino to handle ...